Analysis of Blade Installation and Essentials of Electric Shears

Electric cutting plate machine blade gap can not be anyone can be transferred, not the best professional I do not tune, the first with your machine is the knife after the transfer gap, or training control, should the whole messy, It will step by step gently tune. The first will be adjusted to 50 wire, from scratch has been a grid with a feeler to adjust, plus the first one will not have another tune and then re-adjust the look, and finally the knife-edge display adjusted to zero. Then do carefully control. At this time you want to ensure that the three-wire into the five-wire can not be into it. Jidi his screws are a pull a pull or two, be sure to seriously, whether it will bite the knife. In fact, when it comes to easy to do some attention. . .

1, electric shears should be dedicated to use and custody. Editor must understand the structure of the sawing machine, function.

2, prohibit the use of electric overload shearing machine. Shall not shear hardened steel and hard steel, high speed steel, alloy steel, castings and non-metallic materials.

3, the blade edge should be kept edge, edge blunt or damage, should be repaired in time or swap.

4, multi-person operation should be designed to refer to the command, to understand concord.

5, electric shearing machine is strictly prohibited while cutting two different models of materials, are not allowed to overlap shear.

6, shearing into the material is prohibited when the handrails contributed to the following operation plate. Cut short material should be used to suppress the other iron, cut the material when the fingers leave the blade at least 200 mm.

7, with the pry holding the line, it should be immediately pulled out of the pry out before cutting, such as iron have to move around, the application of wood pillow plug in order to avoid the pressure after the paw paw hand holding up the pop-up wounding.

8, cut a good part must be placed secure, do not stack high, not allowed to pile up to the aisle. Corners and waste materials should be cleared in time to keep the site neat.